3 LB Stainless Steel Tumbling Media Pins - 0.047 Diameter, 0.255 Length

Manufactured from extremely tough 302/304 stainless steel so the pins will last for thousands of cleanings Package includes 3 pounds of reusable precision cut pins for use in rotary or magnetic tumblers Stainless steel pins never wear out and will last a lifetime. These are perfect for use in a wet tumbler for polishing brass, steel, aluminum, or titanium. 047 diameter prevents the pins from getting stuck side by side in flash holes but they will pass through all flash holes one at a time. Fill your tumbler with pins and brass but be sure to leave space to allow tumbling action. Add clean hot water until the tumbler is nearly full. Cold water will work just fine but hot water cleans faster. Add approximately ½ tablespoon Dawn liquid dish detergent (or comparable brand) per 1 lb of brass. The amount of detergent used is not critical but must be enough to ensure good suds remain at the end of the cycle. When first starting out check every 15 minutes to see if additional cleaning is necessary. If you don't see suds after you open your tumbler either you are not using enough soap or the soap is breaking down from running too long. As soon as the agitation stops the dirt will start to stick back on the brass so don't leave it sitting idle in dirty water. Shake dry the brass in a colander and then pour them into the center of a large towel laid out flat.